Using A.m. Mode (Ux-A760); Reception To Memory - Sharp UX-A760 Operation Manual

Using A.M. Mode (UX-A760)

Using A.M. Mode (UX-A760)
When A.M. mode (
the UX-A760 to activate the answering
system, faxes are received
automatically. For more information,
see Chapter 4.
UX-P710 only:
Using the machine with an
existing answering system
If you have an answering system (in a
phone or other device) connected to
the same line as the machine and you
want to receive both faxes and voice
messages while you are out, follow
these steps.
1
Make sure that the machine's Fax
Signal Receive setting is set to
YES (page 29). (This enables the
machine to automatically begin fax
reception if it detects a fax tone
after the answering system
answers a call.)
2
Make sure your answering
system's greeting is no longer than
20 seconds, and insert several
seconds of silence at the beginning
of the greeting. (This will allow the
machine to clearly detect fax tones
when a fax is being sent.)
3
When you go out, make sure the
machine is set to TEL mode (
until TEL appears in the
display
). (The machine should not
automatically answer calls; only the
answering system should answer.)
30
) is selected on
press

Reception to Memory

The machine is set to initially receive
faxes to memory and then automatically
print them out.
This allows reception to take place even
if there is no paper in the paper tray, or
when a problem occurs that prevents
printing such as no imaging film or a
paper jam. Received faxes are held in
memory until paper is loaded in the tray
or the printing problem is resolved. After
you load paper or otherwise resolve the
problem, press
faxes.
♦
When there is no paper in the tray and
a fax has been received to memory,
[ADD PAPER & ]/[PRESS START
KEY] will appear. If a printing problem
has occurred, a message indicating
the problem will appear in the display.
♦
Received faxes are automatically
cleared from memory after they are
printed out.
♦
If the memory becomes full, fax
reception will not be possible (see
"Memory capacity" on page 2 for the
number of pages that can be held in
memory).
♦
When receiving a halftone fax, the
memory may become full before
reception is completed ([MEMORY IS
FULL] will appear). In this case,
change the Fax Receive setting to
"PAPER" (see page 31), and ask the
sender to send the fax again.
START
to print the