Sharp UX-A760 Operation Manual page 39

2
Enter your remote code number and
then press .
•
You will hear a series of beeps equal
to the number of messages
recorded, or one long beep if four or
more messages have been received.
The machine will then play back the
messages. When all messages have
been played back, you will hear a
long beep.
•
If no messages have been received,
you will hear a short beep. You can
either hang up, or perform any of the
remote operations described in the
following section.
3
While the messages are playing,
you can do any of the following:
•
Repeat: Press
•
Skip forward: Press
•
Stop playback: Press
After stopping playback, you can
enter any of the remote commands
described in the following section.
•
Play new messages only: First stop
playback by pressing
and then press
•
Erase: To erase the message you
are currently listening to, press
.
4
When you have finished listening to
your messages, you can do any of
the following:
,
.
, .
, .
, ,
, .
,
Remote Operations
•
Erase all messages: Press
, .
•
Repeat playback: Press
.
•
Perform other operations: You can
enter any of the remote commands
described in the following section.
•
Hang up: Before hanging up, press
twice if you want the machine
to resume normal operation
immediately (in some cases, the
machine may not accept new calls
for one or two minutes after you
hang up unless you press
twice).
Comments:
♦
If you enter an incorrect command, or
pause too long while entering a
command, you will hear 4 beeps. Re-
enter the correct command.
♦
If you wait more than 10 seconds
before entering a command, or enter
your remote code number incorrectly
twice in a row, you will be
disconnected.
,
,
37