Remote Operations - Sharp UX-A760 Operation Manual

Remote Operations

Remote Operations
When you are out, you can call the
machine from any touch-tone telephone
and listen to your messages using the
remote commands.
Remote code
To listen your messages from an
outside phone, you must enter a 3-digit
remote code. The remote code has
been set to "001" at the factory. If you
wish to use a different number, follow
the steps below.
1 F
Press ,
2
Enter the desired 3-digit code.
START
3
Press
4
Press
Toll Saver
When you call the machine to listen to
your messages, it will answer after two
rings if it has received at least one
message, or after four rings if it has not
received any messages.
This allows you to save money on
telephone charges, particularly if you
are calling long distance. If the machine
does not answer after two rings, you
can simply hang up before it answers,
saving yourself the cost of that call.
36
, , and .
.
to exit.
If you do not want to use the Toll Saver
function, you can turn it off by following
the steps below. In this case, the
machine will answer after the number of
rings set with the Number of Rings
setting (see page 27).
Initial setting: YES
1 F
Press ,
2
Press (YES) to turn on the Toll
Saver function.
Press (NO) to turn off the Toll
Saver function.
3
Press
Retrieving your messages
1
Call the machine from a touch-tone
telephone. When your outgoing
message begins, press
telephone.
•
You will hear a short beep, and the
outgoing message will stop.
•
If the machine is in FAX mode, press
immediately after the machine
answers (before you hear the fax
tone).
Note: If the machine's memory is full,
the machine will answer after 20 rings
and the outgoing message will not play.
In this case, start from Step 2.
, , and
to exit.
on the