Sharp UX-A760 Operation Manual page 57

FILM END
KEY LOCK
MEMORY IS FULL
MESSAGE #
(UX-A760 only)
NO # STORED
ON HOOK DIAL
OVER HEAT
PAPER JAMMED
PRINT HEAD FAIL
PRINTER ERROR
PRINTING
READY TO SEND
Open the operation panel and the print compartment
cover and check the imaging film (see Replacing the
imaging film on page 9). If the film has completely
wound onto the front spool, replace the film. Otherwise,
make sure the film is loaded correctly and remove any
slack.
The Key Lock function has been activated. See page
44.
The memory is full. This may occur during fax reception
if too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional message
will indicate the problem), resolve the problem so that
printing can continue (see page 30).
The indicated number of messages are recorded in the
answering system.
This appears if you attempt to search for an auto-dial
number when none have been stored.
The key has been pressed and the fax machine is
waiting for you to dial.
The print head has overheated. Operation can be
continued after it cools.
A paper jam has occurred. Remove the jam as
explained on page 59.
The print head has failed and requires service.
A printer error has occurred. Try the operation again.
The machine is preparing to or printing out a document
from memory.
A document has been loaded and the fax machine is
waiting for you to begin faxing or copying.
Messages and Signals
55