Recording The Sound Of Digital Components - Sony DHC-EX880MD Operating Instructions Manual

Recording the sound
of digital components
N
0 10
)
n
0
N
1
Insert a recordable MD (see page
24).
2
Press FUNCTION >/ . on the
amplifier repeatedly to select the
sound source.
Select "VIDEO 1" ("CS/BS" for
DHC-MD717) to record the sound of a
component connected to the VIDEO1
jacks (CS/BS jacks for DHC-MD717).
Select "VIDEO 2" ("LD/DVD" for
DHC-MD717) to record the sound of a
component connected to the VIDEO2
jacks (LD/DVD jacks for DHC-MD717).
3
Press REC 1 – 3 for the slot
containing the recordable MD.
The MD deck stands by for recording.
4
Press ·∏ on the MD deck (or
MD P
on the remote).
Recording starts.
To stop recording
Press p
on the MD deck.
2
§
= +
·∏
p
p
1 4 3
If "Analog REC!" appears
The optical cable is not connected, so the
system is making an analog recording of the
sound from the VIDEO1 or 2 jacks (CS/BS or
LD/DVD jacks for DHC-MD717).
Note
Once the system has been set to analog recording,
you must first switch the function to other than
"VIDEO 1" or "VIDEO 2" ("CS/BS" or "LD/DVD"
for DHC-MD717) to make a digital recording. In
such a case, stop the recording and connect the
optical cable, then press FUNCTION >/.
repeatedly to select "VIDEO 1" or "VIDEO 2" ("CS/
BS" or "LD/DVD" for DHC-MD717) again.
To record with the optional
TC-TX770 tape deck (for
DHC-EX880MD only)
Do the procedure in "Listening to the sound
of digital components" to listen to the
broadcast, then start recording with the deck.
Tips
• When you connect a digital component using an
optical cable, the system makes a digital recording
of the sound from the digital component. When
you do not connect an optical cable, the system
automatically makes an analog recording of the
sound input from the audio cord. "Analog REC!"
appears when analog recording starts.
• A built-in sampling rate converter lets you make a
digital recording of the sound from a digital
component to the MD deck regardless of the
source frequency (32 kHz, 44.1 kHz, 48.0 kHz).
When recording is completed
Press § and eject the MD. "TOC Writing" flashes
and the MD Table of Contents (TOC) is updated.
While "TOC Writing" is flashing
Do not move the deck or pull out the power cord to
ensure the complete recording. The deck is currently
updating the Table of Contents (TOC).
83