Sony DHC-EX880MD Operating Instructions Manual page 14

Step 3: Presetting radio stations
(continued)
Storing the radio station
5
Press MENU/NO, then turn
MULTI CONTROLLER until
"Memory ?" appears.
6
Press ENTER/YES.
7
Turn MULTI CONTROLLER and
select the desired preset number.
For DHC-EX880MD:
Select from 1 to 20 for FM, 1 to 10 for
MW, or 1 to 10 for LW.
For DHC-MD717:
Select from 1 to 20 for FM, or 1 to 10 for
AM.
8
Press ENTER/YES.
"Complete" appears and the station is
stored.
9
Repeat steps 2 to 8 to store other
stations.
14
To tune in a radio station with a
weak signal
For DHC-EX880MD:
Press TUNING MODE repeatedly until
"TUNING" appears in step 3, then turn
MULTI CONTROLLER to tune in the desired
station.
For DHC-MD717:
Press MANUAL in step 3, then turn MULTI
CONTROLLER to tune in the desired station.
When you have tuned in the station, continue
from step 5.
To change the preset number
Start over from step 2.
To change the AM tuning interval
(DHC-MD717 only)
The AM tuning interval is factory-preset to
9 kHz. To change the AM tuning interval,
tune in any AM station first, then turn off the
system. While holding down the ENTER/
YES button, turn the system back on. When
you change the interval, all the preset stations
will be erased. To reset the interval, repeat the
same procedure.
Tips
• The preset stations are retained for a day even if
you pull out the power cord or if a power
interruption occurs.
• You can label the preset stations (see page 69).