Setting The Cut Position; Setting The Dispense Position; Setting The Backfeed Distance - Avery Dennison Monarch Tabletop Printer 1 System Administrator Manual

Setting the Cut Position

This function adjusts where the tag is cut. The printer adjusts the cut position according
to the index marks on the supply. Aperture supplies may need adjustments. Increase to
move the cut up; decrease to move the cut down.
Select To

Decrease the setting. Moves the cut down.

Increase the setting. Moves the cut up.
Note: Press the left function button to change the amount (by 1, 10, or 100).

Setting the Dispense Position

This function adjusts the amount to advance each label to allow for easy removal from the
printer.
Select To

Decrease the setting. Moves the print down.

Increase the setting. Moves the print up.
Note: Press the left function button to change the amount (by 1, 10, or 100).

Setting the Backfeed Distance

The function adjusts the amount to move the label backwards at the start of each batch
(or label in on-demand mode). The backfeed distance should be equal to or less than the
dispense position. If the backfeed distance is greater than the dispense position, the
dispense position automatically changes to match the backfeed distance.
Select To

Decrease the setting. Moves the print down.

Increase the setting. Moves the print up.
Note: Press the left function button to change the amount (by 1, 10, or 100).
When tearing butt cut supplies, the backfeed distance must be 30 dots (0.15
inches) less than the dispense position. This causes a 30-dot non-print zone on
the supply, but prevents exposed adhesive under the printhead.
Setting Supply Options 2-9