Downloading A Script; Enabling A Script - Avery Dennison Monarch Tabletop Printer 1 System Administrator Manual

V i e w i n g S c r i p t I n f o r m a t i o n
You can view information about a loaded script.
Select
Script Info
Note: If a script is already loaded, see
download a script, see
D o w n l o a d i n g a S c r i p t
Follow these instructions to download a script from the command prompt. Set the
communication parameters using the MODE command. Then, prepare the printer to
accept a script.
Select
Load Script
Note: Only one script can be loaded in the printer at a time.
Send the script file to the printer.
When downloading a script, if you receive an error:
♦
Check the available flash memory. See
Chapter 6 for more information.
♦
Format flash memory. See
information.
After downloading a script, if the script does not appear to be loaded, try formatting flash
memory and download the script again.
E n a b l i n g a S c r i p t
The script must be enabled before you can use it.
Select
No
Yes
Note: When a script is not loaded, this message appears:
7-2 Operator's Handbook
To
View the information about the loaded script.
If a script is not loaded, you see "No script loaded."
If a script is loaded, you see the script name and version number.
"Formatting Flash
To
Prepares the printer to accept a script file.
"Formatting Flash
To
Does not enable the script. (Stop the script).
Start the script. When you turn the printer off and back on, the script
automatically starts.
When you see "Ready," the word "Script" appears in the upper
left-hand corner of the display.
"Enabling a Script," to continue. If you need to
Memory" in Chapter 6.
"Checking Available Flash
Memory" in Chapter 6 for more
Memory" in