Cut Position; Dispense Position - Avery Dennison Monarch 9855 RFID Operator's Handbook Manual

Cut Position

This function adjusts where the tag is cut. The printer adjusts the cut
position according to the black marks on the supply. You may need to adjust
for aperture supplies. Increase to move the cut up; decrease to move the
cut down.
To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Then, follow these steps.
1. Press or
POSITIONING
Cut Pos
Press Enter/Pause. The current setting is displayed, for example:
2.
Enter knife adj
[-300/300]: +0
3. Press or
value (moves the cut down);
4. Press Enter/Pause when the number you need appears. Press
Escape/Clear until you see the Main Menu.

Dispense Position

This function adjusts the stopping point of the label.
To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Follow these steps.
1. Press or
POSITIONING
Dispense Pos
2. Press Enter/Pause.
DISPENSE POS
[50/200]: +65
Press or
3.
the value;
Press Enter/Pause when the number you need appears. Press
4.
Escape/Clear until you see the Main menu.
4-12 Operator's Handbook
until you see
to change the cut position. Pressing
until you see
to change the dispense position. Pressing
increases it.
increases it (moves the cut up).
decreases the
decreases