Setting The Speed; Recommended Maximum Pint Speeds - Avery Dennison Monarch Tabletop Printer 1 System Administrator Manual

S e t t i n g t h e S p e e d
Select the print speed in IPS (inches per second). If print quality is important, reduce the
print speed - a lower print speed increases the print quality of labels. Use premium
supplies when printing at high speeds.
Select To
2.5 IPS Print at 2.5 IPS.
4.0 IPS Print at 4.0 IPS.
6.0 IPS Print at 6.0 IPS.
8.0 IPS Print at 8.0 IPS.
When using Easy Setup to configure the printer for RFID supplies, the print speed may be
decreased. For example:
Inlay
AD-318M5GWC
AD-318M5GWC

Recommended Maximum Pint Speeds

Options:
300 dpi supported
printhead
Tags supported
TuffMark® 2.5 ips
Supply maximum
recommended
Serial bar 2.5 ips
codes maximum
recommended
Liner Take-up supported
Cutter & supported
Stacker
Peel Mode supported
Bar Code supported
Verifier
Note: If you change the speed, you must resend your formats or turn off the printer and
back on before the change takes effect.
If you change the speed in offline mode, turn off the printer then turn it back on
before the change takes effect.
2-4 System Administrator's Guide
Select
10.0 IPS
12.0 IPS
Default
Selected Speed
8.0 IPS
4.0 IPS
Print Speed, inches per second
2.5/4.0/6.0
supported
supported
not
recommended
not
recommended
supported
supported
supported
not
recommended
To
Print at 10.0 IPS.
Print at 12.0 IPS.
Print formats with serial bar codes
at 2.5 inches per second and
formats with parallel bar codes at
6.0 inches per second.
RFID Easy Setup Configured Speed
6.0 IPS
Easy Setup changes the printer to print 6.0 ips.
4.0 IPS
Easy Setup does not adjust the print speed.
8.0 10.0
not supported
not recommended
not
recommended
not
recommended
not supported
not supported
not supported
not recommended
12.0
not supported
not recommended
not
recommended
not
recommended
not supported
not supported
not supported
not recommended