Setting The Error Action - Avery Dennison Monarch Tabletop Printer 1 System Administrator Manual

S e t t i n g t h e E r r o r A c t i o n
Sets how the printer recovers/responds to a bad RFID inlay. Selecting overstrike and
continue 1x-5x sets the number of times the printer prints an overstrike pattern on
consecutively bad labels before generating an error. The user must clear the error before
operation can continue. The overstrike pattern prevents someone from using a bad label.
Note: Do not use the overstrike action with peel mode.
Select
Normal
Overstrike/Continue 1x
Overstrike/Continue 2x
Overstrike/Continue 3x
Overstrike/Continue 4x
Overstrike/Continue 5x
Example: Error action is set to overstrike/continue 3x:
If the printer errors on the first label, an overstrike pattern is printed, but the printer
attempts to reprint the image up to three times. If the third consecutive label also
generates an error, an overstrike pattern is printed; however, the printer stops and the
error message is displayed. The operator must resolve the error condition before printing
continues.
In the above example, if the third label did NOT generate an
error,
♦
the batch image is printed
♦
the consecutive error counter is reset
♦
the printer continues processing the batch.
To
Display the error. The error must be cleared before operation
can continue. Press CANCEL to clear the error and continue
printing. No overstrike pattern is printed.
Attempt to reprint the label for one, two, three, four, or five
consecutive tries. An overstrike pattern is printed each time the
reprint fails. Printing is stopped after the selected number of
overstrike patterns have printed. Press CANCEL to clear the
error and continue printing. Do not use the overstrike label.
Sample O verstrike Label
Setting Supply Options 2-11