Symbols Used; Installation Instructions Intended Use; Approval; Regulations - Truma Combi D 6 Installation Instructions Manual

Table of Contents
Symbols used ...................................................................... 13
Installation instructions
Intended use ........................................................................ 13
Approval .............................................................................. 13
Regulations .......................................................................... 13
Installation instructions for vehicles .................................... 14
Selecting a location ......................................................... 14
Securing the appliance .................................................... 15
Exhaust and combustion air ducting ............................ 15
Permissible duct lengths ..................................................... 15
Installing the wall cowl ........................................................ 15
Extraction air supply ............................................................ 17
Circulated air intake ......................................................... 17
Warm air distribution ...................................................... 17
Fuel line connection ......................................................... 18
Safety instructions for routing fuel lines .............................. 18
Installing the metering pump .............................................. 18
Fuel tank removal kit ....................................................... 19
Water connection ............................................................. 19
Installing the FrostControl (safety/drain valve) .................... 20
Water pipe connection / routing .......................................... 20
Room temperature sensor installation ......................... 20
Fitting the control panels ................................................ 21
Electrical connections ..................................................... 21
12 V voltage supply ............................................................. 21
Room temperature sensor ................................................... 22
Control panels / air conditioning system ............................. 22
Metering pump .................................................................... 22
Extractor fan ........................................................................ 22
230 V ~ voltage supply ........................................................ 22
Initial start-up .................................................................... 22
Filling the fuel lines .............................................................. 22
Function check ................................................................. 22
Warnings ........................................................................... 22

Symbols used

The unit must only be installed and repaired by an
expert.
Symbol indicates possible hazards.
Note containing information and tips.
Observe the ESD regulations. Electrostatic charging can
cause destruction of the electronics. Ensure that poten-
tial compensation is present before touching the electronics.
Installation instructions
Read the installation instructions care-
fully before commencing the work, and
then comply with them.
Disregarding installation instructions or erroneous
installation can put people in danger and cause
damage to property.
Observe the ESD regulations.
Intended use
The Combi D 6 (E) diesel heater is a warm air heater with an
integrated hot water system (10 litre volume). This unit was
designed for installation in motor homes and caravans.
The Combi D 6 E has additional electric heating elements for
operation with a mains voltage of 230 V ~.
An additional altitude kit (part no. 34610-01) is required for
long periods of operation at altitudes of 1500 to 2750 m.

Approval

The heater is approved for installation in passenger vehicles
(class M1 motor homes) with a maximum of 8 seats excluding
the driver's seat, and for trailers (class O caravans).
Installation inside buses and vehicles (vehicle classes M2 and
M3) is not permitted.
The applicable regulations must be complied with when the
equipment is being installed in special vehicles and vehicles
for transporting hazardous goods.
The year when the equipment was first put into oper-
ation must be indicated with a cross on the type plate.

Regulations

Guarantee claims, warranty claims and acceptance of liability
will be ruled out in the event of the following:
- Modifications to the appliance (including accessories),
- Modifications to the exhaust duct and the cowl,
- Use of replacement and accessory parts other than original
Truma parts,
- Failure to follow the installation and operating instructions.
The appliance's operating permit, and consequently also the
vehicle's operating permit in some countries, are also ren-
dered void.
13