Advertisement

Combi (E)
EN
Operating instructions
To be kept in the vehicle
Page
02

Advertisement

Table of Contents
loading

Summary of Contents for Truma Combi Series

  • Page 1 Combi (E) Operating instructions Page To be kept in the vehicle...
  • Page 2: Table Of Contents

    Combi (E) 1 Control panel, digital or analogue (no picture) 2 Room temperature sensor 3 Cold water connection 4 Hot water connection 5 Gas connection 6 Warm air outlets 7 Circulated air intake 8 Exhaust gas discharge 9 Combustion air infeed 10 Electronic control unit 11 Water container (10 litres) 12 Burner...
  • Page 3: Safety Instructions

    • Switch off the heater at the control panel. tion test, at the same time observing the in- • Switch off the heater via the Truma App if a stallation and operating instructions and the Truma iNet Box is installed.
  • Page 4 – The installer or vehicle owner must affix the supplied yellow sticker with the warning – We recommend the Truma MonoControl CS information in a location in the vehicle gas pressure regulator for vehicles, and also where it is clearly visible to all users (e.g.
  • Page 5 The Truma – Hot air can be dangerous particularly to MonoControl CS gas pressure regulator sat- toddlers, children, older or infirm people isfies this requirement.
  • Page 6: Function Description (Combi)

    – Modifications to the appliance (including Function description(Combi E) accessories), (in conjunction with the Truma CP plus control panel) – Modifications to the exhaust gas system The liquid gas heater Combi E is a warm-air heater with inte- and the cowl, grated hot water boiler (10 litres volume).
  • Page 7: Operating Instructions

    The water Operating instructions can be viewed in offline mode temperature depends on the selected operating mode and the with a mobile device and the Truma App. Download the heater output. operating instructions when you have a WiFi connection and save them on your mobile device.
  • Page 8: Drain Valve

    Even if only the cold water system is being operated without hot water, the boiler will still fill with water. To Truma supplies a heating element (part no. 70070-01) as an avoid frost damage, the boiler must be drained via the safety / accessory, which is plugged into the FrostControl and fixed drain valve, even if it was not operated.
  • Page 9: Switching Off

    Fuses – Check to make sure the cowl is unobstructed. Be sure to remove any covers that may be present. Electrostatic charging can destroy the electronics. Ensure that potential compensation is present before It is forbidden to fit cowl covers. touching the electronics.
  • Page 10: Overheating Protection 230 V ( Combi E)

    Dimensions Technical data Determined in accordance with EN 624 or Truma test conditions Gas type Liquefied gas (propane / butane) Operating pressure 30 mbar (see type plate)
  • Page 11: Faults

    Truma iNet Box Boiler cannot be drained, Safety / drain valve drain- The Truma iNet Box for simple networking and control of even though the safety / age socket blocked. / Check Truma appliances with a smartphone or tablet computer using drain valve is open.
  • Page 12: Manufacturer's Warranty (European Union)

    The Manufacturer or an authorised service partner by Truma or if the Truma control unit (e.g. Truma CP plus or undertakes to remedy such defects through subsequent Truma iNet Box) has not been exclusively used for control- fulfilment, i.e.
  • Page 13 Should problems occur, please contact the Truma Service Centre or one of our authorised service partners (see www.truma.com). In order to avoid delays, please have the unit model and serial number ready (see type plate). Truma Gerätetechnik GmbH & Co. KG Service Wernher-von-Braun-Straße 12...

Table of Contents