Table of Contents
Advertisement
User's Manual
Figure 39 — Schedule – Settings (Advanced Mode) setup screen.
NOTE: Channels that are not defined will use the setting values of the previous schedule item.
When multiple events are detected at the same time from a specific channel, the DVR will record event
video with the high setting values if the ips, Quality, Resolution and Dwell values of events are different
from each other. However, the ips will be reset to the supported maximum value when the ips, Quality,
Resolution and Dwell are all set to the highest value. (Advanced Mode Only)
Highlight the box under the
confirm that you want to delete the settings.
Highlight Default... and press the
Highlighting boxes under Quality and pressing the
Event recording. You can select from: Very High, High, Standard and Basic.
Highlighting boxes under Resolution and pressing the
Time and Event recording. You can select from: Very High (D1), High (Half D1) and Standard (CIF).
Highlighting boxes under Dwell and pressing the
for the associated event. (Advanced Mode Only)
Pre-Event
Highlight Pre-Event in the Record menu and press the
do not have Event set up in the Record Schedule, a message will display alerting you to this fact.
Figure 40 — Pre-Event setup screen.
30
You can set the ips, Quality and Resolution (ips, Quality,
Resolution and Dwell for Advanced Mode setup) of the
recording for any modes you set up in the Mode column. If
you do not set the ips, Quality, Resolution and Dwell in the
Settings column, the DVR will follow the default settings.
See below for details.
NOTE: Descriptions of the Record icons in the Type
heading and press the
button to delete the recording settings. You will be asked to
button. The Default screen appears.
Highlighting boxes under ips and pressing the
you to set the images per second for Time and Event recording.
You can select from 1.00 to 30.00 ips (25.00 ips PAL).
button allows you to set the recorded image quality for Time and
button allows you to set the length of time you would like to record
When the DVR is in the Event Record mode it is possible to
have it record images before the event occurs. The Pre-Event
screen allows you to define how to handle pre-event recording.
You can turn individual cameras On or Off for pre-event
recording. The image speed can be set from 1.00 to 30.00 ips
(25.00 ips PAL), image quality can be selectable from Very
High, High, Standard and Basic, and image resolution can
be selectable from Very High (D1), High (Half D1) and
Standard (CIF).
You can set the amount of time to record prior to the event
by adjusting the Dwell. You can set the Dwell from 5 seconds
to 30 minutes. The longer the dwell set, the fewer maximum
ips can be set.
column are as follows:
Time-lapse (Time)
Motion
Video Blind
button allows you to set the recorded image resolution for
button, and the Pre-Event setup screen appears. If you
Alarm-In
Video Loss
Text-In
button allows
Advertisement
Table of Contents
