Appendix A Lightning Protection Of The Switch - H3C S3600 Series Installation Manual

Installation Manual
H3C S3600 Series Ethernet Switches

Appendix A Lightning Protection of the Switch

A.1 Installation of Lightning Arrester for AC Power (Socket
Strip with Lightning Protection)
Caution:
Lightning arrester will not be shipped with the switch. You should purchase it by
yourself if needed.
If an outdoor AC power cord should be directly led to the switch, please serially connect
the lightning arrester for AC power (Socket Strip with Lightning Protection) before you
plug AC power cord into the switch, thus to prevent the possible damage to the switch
due to lightning strike. You can use cable clips and screws to fasten the lightning
arrester for AC power on the cabinet, workbench or the wall of equipment room.
Normal operation indicator (green):
On means that the arrester works normally. Otherwise, it
means that the protection circuit has been damaged.
Figure A-1 Diagram of lightning arrester
Grounding and polarity indicator (red) :
On means that the lines are wrongly connected
(either the ground wire is not well connected, or the live and zero lines are wrongly connecte
Please check the power supply circuit.
Mainboard
Multipurpose power socket, connected to the device
protected by the arrester
A-1
Appendix A Lightning Protection of the Switch
Power socket (compli
connected to the po
through power cord
Overload auto
which can be
d).
Po wer switch
ed with IEC standard),
wer supply of the equipment room
protector,
manually reset.