Installation Manual
H3C S3600 Series Ethernet Switches
When you install S3600 series into 19" standard cabinets, you should select front and
rear mounting ears listed in Table 3-2.
Table 3-2 Selection of mounting ears for the S3600 series
H3C S3600-28P-SI
H3C S3600-28TP-SI
H3C S3600-52P-SI
H3C S3600-28P-EI
H3C S3600-28F-EI
H3C S3600-52P-EI
H3C S3600-28P-PWR-SI
H3C S3600-28P-PWR-EI
H3C S3600-52P-PWR-SI
H3C S3600-52P-PWR-EI
II. Use front mounting ears to install a switch
Follow these steps to mount a switch into a 19-inch standard cabinet:
1)
Wear an ESD-preventive wrist strap and check the grounding and stability of the
cabinet.
2)
Take out the screws which are packed together with the front mounting ears, and
fix one end of mounting ears to the switch, as shown in Figure 3-3.
Figure 3-3 Fix front mounting ears (1)
3)
Place the switch horizontally in a proper position, and fix the other end of mounting
ears to the front brackets with screws and captive nuts, as shown in Figure 3-4.
Model
43.6 × 440 × 260
mm (1.7 × 17.3 ×
10.2 in)
43.6 × 440 × 420
mm (1.7 × 17.3 ×
16.5 in)
Configuratio
Physical
n type of
dimensions
mounting ear
Standard
Standard
3-3
Chapter 3 Installation
Configuration
type of rear
front
mounting ear
—
Standard
Front panel