H3C S3600 Series Installation Manual page 71

Installation Manual
H3C S3600 Series Ethernet Switches
Step 3: Click <OK>. The Port Settings tab, shown in Figure 4-4, appears and you can
set serial port parameters. Set the following parameters:
Bits per second: 9600
Data bit: 8
Parity check: none
Stop bit: 1
Flow control: none
Figure 4-4 Setting communications parameters
Step 4: Click <OK>. The HyperTerminal dialogue box appears, as shown in Figure 4-5.
Figure 4-5 HyperTerminal window
Chapter 4 Starting up the Switch at the Initial Boot
4-3