H3C S3600 Series Installation Manual page 17

Installation Manual
H3C S3600 Series Ethernet Switches
LEDs, two 1000Base-X SFP port status LEDs, and two 10/100/1000Base-T
auto-sensing Ethernet port status LEDs. You can learn how the switch operates by
observing the LEDs listed in Table 1-6.
Table 1-6 LEDs on the front panel of the S3600-28TP-SI
LED
AC
power
LED
Mode
LED
10Base-
T/100Ba
se-TX
port
status
LED
Mark Status
Solid green
Flashing green (1Hz)
PWR Solid red
Flashing yellow (1Hz)
OFF
Speed Solid green
Mode
Duplex Solid yellow
Gree
n
Yello
Speed
w
Flashing
yellow (3Hz)
OFF
—
Gree
n
Yello
Duplex
w
Flashing
yellow (3Hz)
OFF
The switch is started normally.
The system is running a POST or
downloading software.
The system fails the POST or a
fault occurs.
Some ports fail a POST or
malfunctions occur.
The power is disconnected.
Rate information of
10Base-T/100Base-TX Ethernet
ports, and 1000Base-X SFP ports.
Duplex information of
10Base-T/100Base-TX Ethernet
ports, and 1000Base-X SFP ports.
ON A 100 Mbps link is present.
Flas Data is being received/sent on the
hing port.
On A 10 Mbps link is present.
Flas Data is being received/sent on the
hing port.
The port fails a POST.
No link is present.
The port is operating in full duplex
ON
mode.
Flas Data is being received/sent on the
hing port.
The port is operating in half duplex
ON
mode.
Flas Data is being received/sent on the
hing port.
The port fails a POST.
No data is being received/sent on
the port.
1-9
Chapter 1 Product Overview
Indication