H3C S3600 Series Installation Manual page 24

Installation Manual
H3C S3600 Series Ethernet Switches
Table 1-9 LEDs on the front panel of the S3600-28P-EI
LED
AC
power
LED
DC
power
LED
Mode
LED
7-
segment
digital
LED
Mark Status
Solid green
Flashing green (1 Hz)
PWR
Solid red
Flashing yellow (1 Hz)
OFF
Solid green
RPS
Solid yellow
OFF
Speed Solid green
Mode
Duplex Solid yellow
POST PWR flashes
running green (1 Hz)
The PWR LED
flashes yellow.
POST
failed
The PWR LED
is solid red.
Unit
Software The PWR LED
loading flashes green.
Fan The PWR LED
failure is red
Button
Unit ID
released
1-16
Chapter 1 Product Overview
Indication
The system passes the
Power-On Self-Test (POST) and
is operating normally.
The system is running a POST or
is downloading software.
The POST of the system fails or
a serious fault is detected.
Some ports fail to pass the POST
and some functions are disabled.
The power is disconnected.
Both the internal AC power
supply and the DC input are
normal.
The internal AC power supply
fails or is disconnected, but the
DC input is normal.
The DC input is not connected.
Rate information of the
10Base-T/100Base-TX Ethernet
ports and the 1000Base-X SFP
ports.
Duplex information of
10Base-T/100Base-TX Ethernet
ports and the 1000Base-X SFP
ports.
Displays the POST test ID (in the
range of 1 to 9).
Flashes the POST test ID of the
failed test.
A bar rotates clockwise around
the LED.
Displays "F".
Displays the unit ID in the fabric;
and displays "1" if there is only
one unit.