H3C S3600 Series Installation Manual page 86

Hide thumbs Also See for S3600 Series:

Table of Contents

Installation Manual

H3C S3600 Series Ethernet Switches

Figure 5-5 Sending File interface

Step 9: After completing loading, the system displays the following information:

Loading ...CCCCCCCCCC done!

Note:

You do not need to reset the HyperTerminal's baud rate and can skip the last step if you

have chosen 9600 bps. In this case, the system does not display the above prompt

message but "BootROM is updating now.....................................done!" instead.

Step 10: Reset HyperTerminal's baud rate to 9600 bps with reference to Steps 5 and 6

described above. Then, press any key as prompted. The system will display the

following information when it completes the loading.

Bootrom updating.....................................done!

III. Loading host software

Follow these steps to download host software of the switch:

Step 1: Select <1> in the Boot Menu. The system displays the following information:

1. Set TFTP protocol parameter

2. Set FTP protocol parameter

3. Set XMODEM protocol parameter

0. Return to boot menu

Enter your choice(0-3):3

Select <3>. The subsequent steps are the same as those for loading Boot ROM, except

for the program to be downloaded in prompt messages.

Chapter 5 Loading Boot ROM and Host Software

5-10

Table of Contents