Corner Horizontal Venting Illustrations - kozy heat Windim-WDM 56101 Installation And Operation Manual

WARNING: A WALL PASS-THRU MUST BE USED ON ALL HORIZONTAL VENT RUNS.
NOTE: Page 18 has information on restrictor installation in conjunction with venting installation. Page 33 has information on
restrictor recommendations depending on burner flame appearance and instructions on installation after venting is completed.
MINIMUM HORIZONTAL VENTING (corner installations - NAT. gas only)
IMPORTANT: This minimum venting configuration is for use with NAT. gas only. See illustration at bottom of page for minimum corner
installation for LP gas. The illustration at bottom of page may also be used for a Nat. gas application if desired.
MINIMUM HORIZONTAL VENTING (corner installations - L.P. gas )
90˚ ELBOW
VENTING
TERMINATION
CAP
6" (152 mm)
45˚ ELBOW
May also be used for a Nat. gas application if desired.
PAGE 19
(CORNER)
CAUTION: This gas appliance must not be
connected to or joined with any other chimney
flue serving another appliance.
IMPORTANT: Flame height and appearance
will vary depending upon venting configuration
and type of fuel used.
6" (152 mm)
90˚ ELBOW
TERMINATION
CAP