Cockpit / Deck Drains - Pro-Line Boats 2009 26 XP Pilot Owner's Manual

If you live in an area where it snows and you are storing your boat on a lift during the winter, make sure that you
remove the drain plug. When the snow melts, if the float switch for the bilge pump happens to fail, it could flood
the bilge and damage electrical components in the bilge.

Cockpit / Deck Drains

There are two (2) cockpit/deck drains in the aft area of the cockpit that allow
excess water in the cockpit to drain overboard via thru hulls on each side of
the boat. To ensure that there is no blockage in any of the hoses connected
to the drains, it is recommended that you occasionally run water through each
of the cockpit drains and visually inspect the thru hulls to verify that water
flows freely and that there is no blockage. To trouble shoot, check the hoses
for leaks and make certain that all hose connections are secure.
Bow Pulpit with Anchor Roller and Rope Locker Storage
We have installed an aluminum anchor roller at the bow pulpit. The anchor line can be secured inside the anchor
locker and then routed through the anchor roller and/or windlass.
equipment) is held on the line beneath the anchor roller. This allows you to move about the bow area safely
without tripping over the line or anchor.
Dive Platform - Integrated with Ladder
An integrated Euro style dive platform is built into the fiberglass construction of the deck and hull and includes a
stainless steel ladder on the port side of the transom.
An optional dive ladder (single engine installations only) can be installed on the starboard side of the dive platform
to allow additional boarding capability. When factory installed, this option includes the installation of an additional
grab rail on the transom. With the engines tilted down, passengers can move easily through the transom door
and across the large dive platform to the optional ladder.
Seating
The 26 XP has plenty of available
seating (shown at the right).
In addition to the standard seating,
you may choose to select the
optional helm bench seat, which
includes storage and aft folding
bench seat.
Hard Top
The molded fiberglass top that encloses the pilothouse is installed on top of the wrap around windshield. A set of
4 rod holders is mounted to the aft legs of the frame; providing you with additional rod holder capacity. Two small
hatches are installed on the fiberglass top to allow for additional air circulation at the helm station.
See the Service and Care section of this manual for cleaning recommendations for the anodized aluminum frame
and fiberglass hard top.
Note: Pro-Line DOES NOT offer outriggers on this model. When outriggers are factory installed
on some of our other models, we install mounting pads to the frame for additional support.
Before considering adding after market outriggers, we recommend that you consult your Pro-Line
Captions Chairs (Standard)
The anchor (not included as standard
Folding Rear Bench (Standard)
32