Resealing - Pro-Line Boats 2009 26 XP Pilot Owner's Manual

•
Prepare engine in accordance with the engine manufacturer's recommendations found in your
engine manual.
•
Treat metal parts with a rust inhibiter.
•
To prevent mold and mildew, use an absorbing product such as DampRid according to the
manufacturer's directions.
charcoal briquettes that have not been pre-treated with lighter fluid.
•
Remove batteries and protect them from freezing. Trickle charge overnight once a month.
•
Place under cover. If the boat is stored on a trailer, loosen tie-down straps and place blocks
beneath axles to relieve the load on the tires.
For inboard/outboard engines only, to protect your boat during transport, the following procedures were affected
at the factory prior to shipping and will need to be rectified prior to launch:
•
Drain plugs on engine block removed.
•
Petcocks on engine removed.
•
Large hose on re-circulating pump removed.
•
Power steering cooler hose removed.
•
All other water hoses disconnected (left in place with hose clamps tightened to prevent their loss).
Fitting Out After Storage
•
Check entire fuel system for loose fittings, leaks and damage.
•
Clean battery terminals; install battery(s), and coat terminals with a deoxidizing agent.
•
Check all thru hull fittings and hoses for obstructions, water tightness and condition.
•
Test all lights for proper operation.
•
Check wiring, terminal blocks and plugs for loose connections and corrosion.
•
Verify switch and equipment operation.
•
Check line condition. Inspect anchor and rope.
•
Clean out any debris from bilge and cockpit.
•
Flush water systems.
•
Install hull drain plug.
•
Verify operation of equipment before leaving dock.

Resealing

In the heat and sun, silicone and sealant can degrade over time. We recommend that you reseal around
everything that comes in contact with the deck or hull with a high quality silicone such as 3M 5200 sealant
annually. This includes but is not limited to the following:
•
Cleats
•
Rubrail
•
Head door
•
Outriggers
•
Grab rails
•
Windlass
Additional Cleaning and Maintenance Products
Flitz
For use on brass, copper, stainless steel, chrome, silver, gold, pewter, nickel, factory gun bluing, bonze, platinum,
tin, aluminum, magnesium, anodized aluminum, painted surfaces, fiberglass, Plexiglas and plastics. Flitz is
available at many marine supply stores, marinas and at Home Depot. For more information on this product,
contact the manufacturer at:
An alternative and inexpensive option is to fill egg cartons with
•
Dive ladder
•
Windshield
•
Motor mounts
•
Thru hull fittings
•
Bow rail stanchions
Flitz International Ltd., Waterford, WI 53185, 800-558-8611
•
Bimini Top hardware
•
Bow and transom eyes
•
Access and other hatches
•
Clam shell at the anchor locker
•
Rigid T-top or Hard-Top stanchions and supports
45