Windlass With Rode And Chain (Optional) - Pro-Line Boats 2009 26 XP Pilot Owner's Manual

Windlass with Rode and Chain (Optional)

The windlass anchor system is located on the Windlass Windlass Switch
bow. It is an electric hands free anchor system
that allows the driver to raise or lower the anchor
while staying at the helm. The windlass comes
with 200 feet of ½ inch line and 6 feet of ¼ inch
rode.
The windlass switch is located at the helm and is
protected by a 50-amp breaker. The. The
breaker is located on the console in close
proximity to the switch.
To operate the windlass, press the windlass toggle switch to the down position to release the anchor and line.
After dropping the anchor, be sure to tie the line off at one of the cleats. If you do not tie off at a cleat, the
constant pull against the line could cause the windlass motor to fail. To retrieve the anchor, press the windlass
switch to the up position and carefully raise the anchor up. Do not allow the anchor to hit the boat.
Refer to the owner's manual that was provided by the manufacturer of the windlass for operational procedures
and information related to the care and maintenance of their product. When in doubt, always defer to the
windlass manufacturer's instructions and/or recommendations.
13