Table of Contents
Advertisement
Electrical System
12 Volt Receptacle
The 12-volt receptacle is installed on the console. It is easily accessible and can be used to charge your cell
phone, operate a hand held remote spotlight, etc.
Air Conditioner (Optional)
The installation of the air conditioner system included the following components:
•
Control knobs (mode and thermostat) are installed on the aft wall of
the cabin.
•
Air conditioning vent – One is installed on the aft wall of the cabin.
Another is installed in the cockpit at the helm.
•
Air conditioner return is installed next to the step on the aft wall of
the cabin.
•
Air conditioner unit is installed behind the air conditioner return.
•
Water pump and seacock are installed below the cabin floor and
are accessible via the round access pie next to the cabin step.
•
On/Off battery switch is installed behind the hatch that is located
next to the fire extinguisher holder.
•
Battery charger is installed behind the hatch that is located next to
the fire extinguisher holder.
•
Shore power inlet is installed in the port aft corner of the cockpit,
above the raw water washdown outlet.
To operate the air conditioner unit:
•
Ensure that the seacock (seawater intake ball valve) is open. The
seacock is open when the seacock lever is in the horizontal
position.
•
Turn the mode control knob to off.
•
Turn on the air conditioning unit circuit breaker.
•
Turn the mode control knob to fan. This energizes the fan.
•
Turn the thermostat control knob to the coolest position by rotating
it fully clockwise.
•
Verify that the fan is running and that there is steady airflow out of
the air conditioning vent.
•
Turn the mode control knob to run. This will start the compressor
and seawater pump.
•
Check for a steady solid stream of seawater from the overboard
discharge (thru hull).
•
To set the thermostat, allow sufficient time for the unit to cool the
area to the desired temperature.
cooled, turn the thermostat knob slowly toward the center position
until it clicks once.
constant temperature.
Caution: Do not turn the unit off and immediately turn it back on. Wait at least 2 minutes for the
system refrigerant pressures to balance.
Please refer to the owner's manual provided by the manufacturer of the air conditioning system and associated
components listed in this section for operational procedures and for information related to the care and
Systems and Accessories
When the area is sufficiently
The thermostat is now set to maintain a
Control knobs
(mode and thermostat)
Air conditioner return
Air conditioning vent
(air supply grille)
14
Advertisement
Table of Contents
