Table of Contents
Advertisement
When you turn off the cockpit shower faucet, the pump may run briefly. If
the pump continues to run with all faucets closed, check the system for
leaks or have the pump tested.
If you should hear a sucking sound, you may have a leak on the inlet side
of the fresh water tank. There are 2 hoses connected to the front of the
tank. The larger diameter hose is the water fill hose and the smaller
diameter hose is the water vent hose. Inspect the hoses for leaks and
make certain that the hose connections are secure.
Note:
The round filter attached to the side of the pump should be
removed and cleaned often with running water.
Fresh Water Tank and Fill (Optional)
The 10-gallon capacity fresh water tank can be filled via
the stainless steel fresh water tank fill (labeled water)
located on the starboard aft corner of the transom. The
tank, which is installed on a shelf in the bilge area, can
be accessed via the bilge hatch in the floor of the aft
cockpit.
To fill the tank, twist the cap on the stainless steel
fitting. The cap is connected to the fitting by a chain or
cable so that it will not fall into the water and/or get lost.
Use a garden hose to fill the fresh water tank through
this fitting.
Important: Fill the tank with potable water only. Refilling the tank often will help to keep it a
source of clean fresh drinking water. Never fill the fresh water tank with anything other than fresh
water.
Fresh Water Cockpit Shower Faucet –Cold (Optional)
The fresh water cockpit shower faucet/nozzle is located just outside the transom door
behind a white cap/cover. Pull open the cap and pull out the faucet/shower nozzle
and hose.
Press the button on the nozzle to ensure proper operation (water
spraying). When you are finished, stow away the transom fresh water hose and cover
the outlet with the white cap.
See the section titled Fresh Water Pump for operating instructions before using this
shower.
Sea Water System
Bilge Pump
The 1100-gph bilge pump and float switch are installed as far aft as
possible in the bilge and both are accessible via the hatch installed in
the motor well. There are 2 steps in properly checking the bilge
pump.
First, turn the bilge pump on at the instrument panel by
pressing the bilge pump switch to the on or forward position. When
the bilge pump switch is in the on position, the switch light should be
illuminated. To check and see if the bilge pump is operating, open
the bilge hatch over the bilge pump and listen to hear the bilge pump
running.
Fresh Water
Pump & Filter
Bilge pump &
float switch
20
Advertisement
Table of Contents
