Table of Contents
Advertisement
Electrical System
12 Volt Receptacle
A 12-volt receptacle is installed on the console. It is easily accessible and can be used to charge your
cell phone, operate a hand held remote spotlight, etc.
Battery
Switch
for
(Optional)
The battery switch on the 25 Walk is installed
behind the hatch located next to the transom
door on the starboard aft corner of the cockp
This switch is for battery isolation, paralle
operation and disconnect.
would install one dual battery switch with
single engine application and two dual batter
switches with a twin-engine application.
The circuit breakers are installed next to the battery switch panel and are labeled aft bilge, forward bilge,
trim tabs, stereo and accessory.
•
Place all the switches in the off position.
•
Turn the ignition key on (both ignition key
the engine will not turn over.
•
Turn the port battery switch to
key to start the port engine.
•
Turn off the port engine ignit
•
Then turn the starboard battery switch to the two (2) position on
starboard ignition key to start the starboard engine.
•
Never switch battery positions while the engines are
T
o ensure that the battery switch/switches will turn off, place the switch/switches in the off position and try
to start up the engine/engines. When the switch/switches is/are off, you should not be able to start the
engine/engines.
Caution: To avoid possible alternator/battery damage on twin-engine installations, make
sure that the dual battery switches are never left so both engines are connected together,
(i.e., never leave a switch on "BOTH" or "ALL" or "1 and 2"). The preferred switch
position is port engine to position one (1) on the port battery switch and starboard engine
to position two (2) on the starboard battery switch.
A
tripped breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit, then reset the breaker by pushing in once or by
returning a breaker switch to the on position. If the breaker does not reset or if it resets and then trips
again after the device is turned back on, then a short circuit exists or your device may be damaged,
overloaded, or faulty. Correct the problem and then reset the breaker.
If
the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either
the breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.
S
witch and Breaker Panel
The switch and breaker panel is located on the console and is equipped with 13 switches. The numbers
shown below each switch in the photo below correspond with the descriptions provided for each switch:
Systems and Accessories
Dual
Batteries
it.
l
Generally, you
a
y
the one (1) position on the switch and turn the port ignition
ion key and the port battery switch.
Starboard Engine
s for a twin engine application) and ensure that
running.
Helm
Port Engine
the switch and turn the
16
Advertisement
Table of Contents
