Overload Reset Switch - Kipor Sinemaster IG3000 Operation Manual

section 5.4 or restoring electrical power from the generator.
The two L5-20 receptacles are rated at 20 amps. Should
this current be exceeded, the circuit protection device will
activate and cut all current to the receptacle. This will be
indicated by the push button popping out. Reduce the load
to the receptacle and reset the circuit protector by pushing
in the button.

5.4 Overload Reset Switch

Should the generator's maximum load of 25 watts be exceeded, AC power will be cut off
but the engine will stay running. Correct the overload condition and then press the
overload reset switch on the front panel. AC power will be restored immediately.
Overload Reset Switch
Ignition Module
Engine switch
■Before connecting an appliance to the generator, check
that it is in good order, and that its electrical rating does
not exceed that of the generator.
■When an electric motor is started, both the overload
indicator light and the output indicator light may go on
simultaneously. This is normal if the overload indicator
light goes off after about four seconds. If the overload
indicator light stays on, consult a service center.
SMART throttle switch
DC receptacle
Choke knob
13
.
Overload protection device
AC receptacle
Ground terminal
Fuel valve lever