Ac Power Applications; Output And Overload Indicators - Kipor Sinemaster IG3000 Operation Manual

and appliance loads up to 10 amps

14 Gauge Cords- a 14 gauge cord between 0 and 50 feet long will adequately handle loads
between 10 and 15 amps.

12 Gauge Cords- If your load is between 10 and 15 amps and the length of the cord is 50 to 100
feet, you need a 12 gauge cord to safely power any tool.
■ Keep the generator away from other electric cables or wires such as commercial
power supply lines.
You may use DC receptacle when using AC supply.
■

5.2 AC Power Applications

1. Start the engine and make sure the green output indicator light comes on.
2. Confirm that the appliance to be used is switched off then plug in the appliance.

5.3 Output and Overload Indicators

The green output indicator light will remain on during
normal operating conditions. If the generator is overloaded
to the point that the max power rating of 25 amps is
exceeded or if there is a short in the connected appliance
the output indicator will go out and the overload indicator
will go on and current to the connected appliance will be
shut off.
Stop the engine if the overload indicator light comes ON and investigate the overload
source. The engine will continue to run even though it is not producing any AC power. See
■Be sure that all appliances are in good working order
before connecting them to the generator. If an appliance
begins to operate abnormally, becomes sluggish, or
stops suddenly, turn off the generator engine switch
immediately. Disconnect the appliance and examine it
for signs of malfunction.
12