Ac Power Applications; Output And Overload Indicators - Kipor SINEMASTER IG6000 Owner's Manual

5.2 AC applications
1. Start the engine and make sure the output indicator light (green) comes on.
2. Confirm that the appliance to be used is switched off, and plug in the appliance.
Applying Loads
CAUTION
■Substantial overloading that continuously lights the overload indicator light (red) may damage the
generator. Marginal overloading that temporarily lights the overload indicator light (red) may shorten the
service life of the generator.
■Be sure that all appliances are in good working order before connecting them to the generator. If an
appliance begins to operate abnormally, becomes sluggish, or stops suddenly, turn off the generator
engine switch immediately. Then disconnect the appliance and examine it for signs of malfunction.

5.3 Output and Overload Indicators

The green output indicator light will remain on during normal operating
conditions. If the generator is overloaded to the point that the max power
rating of 25 amps is exceeded or if there is a short in the connected
appliance the output indicator will go out and the overload indicator
will go on and current to the connected appliance will be shut off.
Stop the engine if the overload indicator light comes ON and investigate
the overload source. The engine will continue to run even though it is
not producing any AC power. The engine must be stopped and then the
generator restarted to resume normal operation.
The 20A duplex receptacle is protected by a push button style circuit
protector. If the current load exceeds 20 amps, the button will pop and
current is shut off to the receptacle. Reduce the load and push the button
back in to restore current.
-12-