Ac Power Applications; Output And Overload Indicators - Kipor IG3000 Owner's Manual

•
12 Gauge Cords- If your load is between 10 and 15 amps and the length of the cord is 50 to 100 feet, you need
a 12 gauge cord to safely power any tool.
■ Keep the generator away from other electric cables or wires such as commercial power supply
lines.
■ You may use DC receptacle when using AC supply.

5.2 AC Power Applications

1. Start the engine and make sure the green output indicator light comes on.
2. Confirm that the appliance to be used is switched off then plug in the appliance.

5.3 Output and Overload Indicators

The green output indicator light will remain on during normal operating
conditions. If the generator is overloaded to the point that the max power
rating of 25 amps is exceeded or if there is a short in the connected
appliance the output indicator will go out and the overload indicator
will go on and current to the connected appliance will be shut off.
Stop the engine if the overload indicator light comes ON and investigate
the overload source. The engine will continue to run even though it is
not producing any AC power. The engine must be stopped and then the generator restarted to resume
normal operation.
■ Be sure that all appliances are in good working order before
connecting them to the generator. If an appliance begins to operate
abnormally, becomes sluggish, or stops suddenly, turn off the
generator engine switch immediately. Disconnect the appliance and
examine it for signs of malfunction.
12