Locating Lighting, Operation And Rating Information Card; Using Remote Control Handset Wall Holder; Servicing Your Fireplace - Valor L2 SERIES Installation & Owner's Manual

2. Slide battery carrier to ease access.
battery box
Slide-in the battery carrier
to access battery box
3. Remove and disconnect the battery box.
Do not pull the box out by the wire!
4. Remove the screw and
slide the cover off.
5. Replace the batteries with
4 AA alkaline batteries
orienting them as indicated
inside the holder.
6. Replace the cover and
screw in place.
7. Reconnect the battery box.
8. Put the battery box back in
its carrier, and push slide
back in to position.
9. Reinstall the plinth, side doors and barrier screen.
Owner's Information
Slide the battery carrier
back into position
Locating Lighting, Operation and Rating
Information Card
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA CARD
WHILE THE FIREPLACE IS STILL HOT! Let the
fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is locat-
ed on a card at the right hand side of the fi replace open-
ing. The card is rolled and attached under the plinth.
Window
The data card is located behind the front panel below
the window at the right-hand side.
To access the card, remove the barrier screen, side
doors and the plinth. Grab the rolled card and pull it out
of its clip. There is important information on both sides
of the card.
Using Remote Control Handset Wall
Holder
Your fi replace equipment includes
a wall holder to store the handset.
If it hasn't be installed, refer to the
instructions further on in this manual
for the installation.

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance's serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.
OWNER'S
INFORMATION
Data
card
9