Repacking The Blackdiamond 8806 Chassis - Extreme Networks BlackDiamond 8800 Hardware Install Manual

11 Secure the BlackDiamond 8810 shipping carton with nylon straps
Figure 114: BlackDiamond 8810 Shipping Carton with Nylon Straps

Repacking the BlackDiamond 8806 Chassis

To repack the BlackDiamond 8806 chassis:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle on the chassis front panel.
2 Remove all modules and power supplies from the BlackDiamond 8806 chassis. Follow correct
Extreme Networks procedures for removing components.
3 Using four rack mounting screws, attach the 19-inch support bracket to the equipment rack
immediately below the chassis.
4 Remove the eight rack mounting screws that secure the chassis to the equipment rack.
5 Slowly guide the chassis out of the equipment rack using the support bracket for support.
BlackDiamond 8800 Hardware Install Guide
Repacking a BlackDiamond 8800 Series Chassis
(see the following figure).
137