Extreme Networks BlackDiamond 8800 Hardware Install Manual page 92

7 Use both hands to latch the injector/ejector handles, by simultaneously pushing both handles
toward the center of the module
Caution
Two different styles of ejector/injector handles are on the BlackDiamond 8800 Series
modules. Pay careful attention to the instructions in the next step.
Figure 65: Injector/ejector Handles in the Latched Position
8 Using a #2 Phillips screwdriver, lock the module into place (see
Place on page 93) in one of the following ways:
•
If the captive screw on each handle has a yellow band around the head of the screw, turn the
screw on each injector/ejector handle clockwise and completely down. When the screw is fully
tightened, the yellow band around the captive screw is completely hidden.
Caution
Be careful to avoid over-torquing and stripping the screw heads.
•
If the captive screw on each handle has a red line on the head (see
Red Line on page 93), turn each captive screw one-quarter turn (90 degrees) clockwise. When
the module is correctly locked, the red line on the captive screw in each injector/ejector handle is
in a vertical position.
Caution
Be sure to turn each captive screw only 90 degrees or one-quarter turn clockwise.
Tightening the captive screws beyond 90 degrees will damage the injector/ejector
handles on the modules.
BlackDiamond 8800 Hardware Install Guide
Installing Modules and Establishing Initial Management Access
(see the following figure).
Figure 66: Locking the Module into
Figure 67: Captive Screw with
92