Chapter 12: Replacing Blackdiamond 8800 Series Chassis Components; Replacing The Fan Tray - Extreme Networks BlackDiamond 8800 Hardware Install Manual

12
Replacing BlackDiamond 8800
Series Chassis Components

Replacing the Fan Tray

Replacing the PSU/Fan Controller
This chapter describes how to remove and replace a fan tray or a PSU/fan controller in the following
BlackDiamond switches:
•
BlackDiamond 8810 switch
•
BlackDiamond 8806 switch
Replacing the Fan Tray
The BlackDiamond 8800 Series switch has one fan tray that is accessible from the front of the switch.
Note
To avoid long periods of operation without forced air cooling, make sure you have the
replacement fan tray ready before you start the replacement procedure.
You need the following tools and equipment to remove and replace a fan tray in a BlackDiamond 8800
Series switch:
•
#2 Phillips screwdriver
•
Replacement BlackDiamond 8800 Series fan tray
Removing the Fan Tray
To remove a fan tray from the BlackDiamond 8800 Series switch:
1 Locate the captive screws at the top and bottom of the fan tray.
BlackDiamond 8800 Hardware Install Guide 125