Extreme Networks BlackDiamond 8800 Hardware Install Manual page 28

10G8Xc I/O Module
The 10G8Xc I/O module
Ethernet ports. This module is over-subscribed 2:1.
Figure 18: 10G8Xc I/O Module
In the default configuration of the 10G8Xc I/O module, all ports:
•
Are added to the default VLAN as untagged
•
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
The 10G8Xc I/O module has the following LEDs:
•
Module status
•
Module diagnostics
•
Port status
For information about the LEDs and their activity on the 10G8Xc I/O module, see
page 35.
BlackDiamond 8800 e-Series I/O Modules
The BlackDiamond 8800 e-Series of I/O modules includes:
•
G48Te2 (see G48Te2 I/O
Caution
ExtremeXOS builds earlier than version 12.1 do not support the G48Te2 I/O module. If you
attempt to install one of these I/O modules before upgrading the software on your MSM to
the required minimum version, the module will not be recognized by the software and it will
not power up. The following error messages are similar to the messages that may be
displayed on the console or in the log. (Samples represent an unrecognized module in slot 2.)
•
Console: ERROR: Unknown cardtype in slot 2 - please program the eeprom
•
Log: <Error: HAL.Card.Error> MSM-A: Unable to read cardtype for slot 2
G48Te2 I/O Module
The G48Te2 I/O module
use standard RJ-45 connectors.
BlackDiamond 8800 Hardware Install Guide
(see the following figure) has eight unpopulated XFP-based 10-gigabit
Module)
(see the following figure) has 48 autosensing 10/100/1000BASE-T ports that
BlackDiamond 8000 Series Modules
I/O Module LEDs on
28