Suzuki GSF1200S 2001 Service Manual page 81

• Tighten the twelve 10-mm nuts in ascending order and to the
specified torque.
" Cylinder head nut: 38 N . m (3.8 kgf . m, 27.5 lb-ft)
• After firmly tightening the twelve 10-mm nuts, install the cylin-
der head bolt (6 mm) 1 and tighten it to the specified torque.
" Cylinder head bolt: 10 N . m (1.0 kgf . m, 7.0 lb-ft)
• Install the cam chain guide 2 as shown.
• While holding down the cam chain, rotate the crankshaft clock-
wise and align the "T" mark on the signal generator rotor with
the center of the pickup coil.
$
Turn the crankshaft using a 19 mm wrench. Never rotate
the crankshaft using a 6-mm T-type wrench.
NOTE:
Before installing the camshafts onto the cylinder head, apply mixed
engine oil/moly paste onto the camshaft journals and do not leave
any dry spots. Also, apply engine oil onto the camshaft journal
holders.
) 99000-25140: SUZUKI MOLY PASTE
ENGINE 3-43