• After remounting the engine, route the wire harness, cables
and hoses properly. (!7-12)
• Install the gearshift lever to the gearshift shaft in the correct
position.
' Gearshift lever height A
Standard: 55 mm (2.2 in)
• Tighten the oil drain plug 1 to the specified torque.
" Oil drain plug: 23 N . m (2.3 kgf . m, 16.5 lb-ft)
• Pour 3.3 L (3.5/2.9 US/Imp qt) of SF or SG classified (API)
engine oil, with a viscosity rating of 10W40 (SAE), into the en-
gine after overhauling it.
• Start up the engine and allow it run for several minutes at idle
speed and then stop the engine. Wait three minutes and then
check that the oil level remains between the marks on the oil
level inspection window.
Oil change
Oil and filter change
Engine overhaul
• Adjust the following items to specification.
*Throttle cable play ............................................... !2-11
*Engine idle speed ............................................... !2-11
*Carburetor synchronization ................................. !4-24
*Drive chain .......................................................... !2-15
3 300 ml (3.5/2.9 US/Imp qt)
3 500 ml (3.7/3.1 US/Imp qt)
4 600 ml (4.9/4.0 US/Imp qt)
ENGINE
3-11