Suzuki GSF1200S 2001 Service Manual page 155

• Remove the float pin 1 and then remove the float 2 and needle
valve 3.
• Remove the following parts.
4 Main jet
5 Needle jet
6 Pilot jet
7 Pilot screw
8 Starter (enricher) jet
9 Valve seat
NOTE:
Before removing the pilot screw 7 , its setting must be determined.
Slowly turn the pilot screw clockwise and count the number of
turns until it is lightly seated. Make a note of how many turns
were made.
When reassembling the pilot screw, you will want to set it to its
original position.
#
Do not use a wire to clean the passages, valve seat and
jets.
• Remove the starter (enricher) plunger assembly 0.
#
* Do not remove the main air jet B.
* It is press fitted at the factory and attempting to re-
move it will cause damage.
• Remove the pilot air jet A.
FUEL SYSTEM 4-17