QUALIFIED
INSTALLER
Re-install Rear Log Support
Refi t the rear log support in place (5 screws).
Install Appliance Into Framing
1. Place the heater in position in the framing.
2. Secure the side support angles to the side studding
through two holes each side with the woodscrews
supplied. The top support angle should abut the wall
fi nish but is not fi xed to the framing.
3. Check the wall fi nish requirements with the
homeowner. If necessary, adjust the position of
the heater so that the distance from the front of
the heater case to the angles is suitable for the
thickness of the wall fi nish (e.g. tile, etc.).
NOTE: When adding optional fronts and trims, it is
important to install heater fl ush or slightly recessed into
the fi nished wall surface.
34
34
Side angle
adjustment
from inside
firebox
Adjustment for wall fi nish
Installation
Reinstall rear support
Top angle
adjustment
from back
of angle
Adjustable for wall finish
material thickness
between 3/8" and 1-3/16"
(10 mm and 30 mm)