Replacing Batteries; Using Handset Wall Holder; Locating Lighting, Operation And Rating Information Card; Servicing Your Fireplace - Valor HORIZON 534JN Installation & Owner's Manual

OWNER'S
INFORMATION

Replacing Batteries

WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
Low battery signal: see page 14.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —see instructions on
next page.
The appliance uses four 1.5 V AA alkaline batteries for
its remote control receiver and one 9 V alkaline battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver:
1. The receiver is located to the left of the valve and it
is retained to the fi rebox by a Velcro tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace batteries with 4 AA alkaline batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the Velcro tab.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further on
in this manual for the installation.
Locating Lighting, Operation and Rating
Information Card
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA CARD .
WHILE THE FIREPLACE IS STILL HOT! Let the
fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information card is
located on a plate under the fi rebox.
8 8
Owner's Information
To access the card, remove any fret or access panel
and grab the card and slide it out to read it. There is
important information on both sides of the card.

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance's serial number can also be quoted. This
number is on the rating plate, which is located under the
burner. The replacement parts are shown at the end of
this manual. Please always quote the part number and
description when requesting spare parts.

Operating Your Fireplace

There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
Thermostatic
Remote Control
The Thermostatic Remote Control can be programmed
to function automatically—see pages 10–14.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
The manual On/Off switch must be ON for the fi replace
to function. It can be used to shut off the fi replace in
case of emergency—see above.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your fi replace.
Handset and Wall Switch: Press and hold the OFF
button for a second (either on the handset or the wall
switch).
Manual On/Off Switch
Wall Switch
(optional)
Wall Switch
Thermostatic
Remote Control (optional)
ON
OFF