Cleaning Your Fireplace - Valor HORIZON 534JN Installation & Owner's Manual

OWNER'S
INFORMATION

Cleaning Your Fireplace

WARNING
!
DO NOT TOUCH THE GLASS WHILE IT IS HOT!
Let the fi replace cool fi rst before cleaning it.
Important - Glass cleaning - Mineral deposits
One of the by-products of the combustion process in
a gas appliance is a mineral which can show up as a
white fi lm on the ceramic glass of the viewing door.
The composition of the deposit varies with location and
time. It is believed to be associated with the varying
sulfur content of the gas. You may have the problem
intermittently.
We have consulted with ceramic glass manufacturers
and they cannot offer a defi nitive solution to this prob-
lem. Dealers have tried various cleaning products with
varying results. The following are recommendations
only and are not meant to guarantee results.
NOTE: This is a problem beyond Miles Industries'
control and is not covered under warranty.
• Clean the glass regularly as soon as you notice
the buildup (white fi lm). If the fi lm is left for a longer
period of time, it will etch into the glass. It is then
much harder, if not impossible, to remove.
• NEVER use an abrasive or ammonia cleaner on
the ceramic glass. Any abrasion of the surface
has the immediate effect of compromising the
strength of the glass. An emulsion type cleaner is
recommended.
• Use a soft damp cloth to apply the cleaner. Dry the
glass with a soft, dry, preferably cotton cloth. Most
paper towels and synthetic materials are abrasive to
ceramic glass and should be avoided.
• Our dealers have had good results from the
products listed below. We cannot, however,
guarantee the results of these products.
•
Brasso, Polish Plus by Kelkem, Cook Top Clean
Creme by Elco, White Off by Rutland, Turtle Wax
Do not clean the glass while it is hot!
Always securely replace the window and the barrier
screen before lighting.
If broken, the glass pane may only be replaced
as a complete window unit as supplied by the
manufacturer.
If the barrier becomes damaged, the barrier shall
be replaced with the manufacturer's barrier for this
appliance.
6 6
Owner's Information
To remove the window for cleaning:
1. Unhook the front or trim with barrier screen
attached.
2. Turn the top two spring-
loaded window bolts
through 90 degrees to
release the window from
the fi rebox.
3. Remove the bottom two
spring-loaded window
bolts.
4. Carefully lift the window
away. Keep the window
and bolts in a safe place.
Clean the window following
the guidelines in this section.
Clean the trim or front with
mild soap and water. Any
alcohol/solvent base cleaner will weaken the coating
and damage it.
Dust the barrier screen with a soft brush.
Dust the fi rebox ceramic logs/rocks and walls
with a soft brush. Dust can also be removed from the
burner using a soft brush after removing the ceramic
logs. When cleaning, make sure that no particles are
brushed into the slots of the burner.
To refi t the window:
1. Refi t the window with the bottom two bolts. The
bolts should be screwed in securely.
2. Refi t the top two bolts securing by turning them
through 90 degrees.
3. Pull the top of the window forward and release to
check that it opens slightly and returns confi rming
the good function of the spring-loaded mechanism.
4. Similarly check the bottom of the window by pulling
it forward and releasing.
Window opening & removal