Install 534Lsk Ceramic Logs - Valor HORIZON 534JN Installation & Owner's Manual

Install 534LSK Ceramic Logs

Unpack the ceramic logs very carefully to avoid damaging their fragile material. Install the logs as shown below.
Please note that the position of the logs is critical to insure the good performance of the appliance.
1. Place the rear log on the sheet metal support
centering it side to side in the fi rebox. Pull it forward
until the notch in the underside of the log sits
against front edge of the sheet metal support.
2. Place the top left log on the pin of the rear log. The
bottom of the log rests against the left of the pilot
shield and slightly above.
Pilot area
Installation
3. Place the front left log on the burner. Slide it to the
left against the top left log. The narrow end should
rest in the notch in the rear log.
4. Place the front right log on the burner and slide it to
the left against the front left log.
5. Locate the top right log on the two pins on the right
side of the rear log. Ensure a tight fi t against the fl at
area around the pins in the rear log.
QUALIFIED
INSTALLER
Pilot area
37 37