Using Handset Wall Holder; Replacing Batteries; Locating Lighting, Operation And Rating Information Card; Servicing Your Fireplace - Valor LEGEND G4 785XN Installation And Owner's Manual

OWNER'S
INFORMATION
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further on
in this manual for the installation.

Replacing Batteries

WARNING
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
Low batteries signal: see page 15.
BEFORE changing the batteries, disconnect the
battery box from the receiver.
The appliance uses four 1.5 V AA alkaline batteries
for its battery box and one 9 V alkaline battery for its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life. Should the batteries
loose power, the control may be operated by manually
turning the control knob at the valve or by turning off
the valve at the switch.
To replace the batteries in the battery box:
1. The battery box is located to the left of
the fi rebox behind the left access door.
Remove the left access door. Grab
the battery box and pull it out from its
location.
2. Disconnect the battery box.
3. Remove the box cover (1 screw).
8
Owner's Information
4. Replace the batteries with 4 AA alkaline batteries.
5. Replace the cover and screw in place.
6. Reconnect the battery box.
7. Put the battery box back in its position.
8. Reinstall the left access door.
Locating Lighting, Operation and Rating
Information Card
DO NOT ATTEMPT TO TOUCH THE DATA CARD
WHILE THE FIREPLACE IS STILL HOT! Let the
fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is
located on a card at the right of the fi rebox. To access
the card, remove the right hand side door, grab the
card and take it out to read it. There is important
information on both sides of the card.

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be help-
ful if the appliance's serial number can also be quoted.
This number is on the rating plate, which is located at
the right of the fi rebox. The replacement parts are shown
at the end of this manual. Please always quote the part
number and description when requesting spare parts.

Fireplace Control Devices

There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the fi replace
Battery
to function. It can be used to shut off the fi replace in
box
case of emergency—see next sub-section.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 10–15.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
WARNING
WARNING
!
Manual On/
Thermostatic Wall Switch
Remote Off Switch
(optional)
Control