Table of Contents
Advertisement
Basic settings
1. After installing the batteries, the display should flash the word
"ENGLISH". If not, press and hold
seconds.
2. Select the desired language using
button.
3. Select the desired contrast setting (2=Default) using
Press DELETE button.
4. Set the hour (00-23) using
5. Set the minute using
6. Set the day using
7. Set the month using
If you wish to change the language, contrast, time settings at a later
date, press and hold
repeat steps 2-7 above.
Operation
When the telephone is not in use, the date and time, number of new
and total number of calls STORED in the Caller ID MEM will be
shown in the display. The display will show the caller number (and
name if available).
Making a call
1. Pick up the handset or press SPEAKER button (the speaker LED
will light) and wait for a dial tone.
2. Dial the number you wish to call. The display will show the
number that you are dialing. If you dial a number over 14 digits
long, it will show the last 14 digits only.
3. When you have completed your call, hang up the handset or
press the SPEAKER button again to release the telephone line.
It is possible to switch from a handset to speakerphone conversation
by pressing the SPEAKER button and picking up or hanging up the
handset accordingly.
or
or
. Press DELETE button.
or
. Press DELETE button.
or
. Press DELETE button.
button for approximately 4 seconds and
7
for approximately 4
or
. Press DELETE
. Press DELETE button.
or
.
Advertisement
Table of Contents
