IDEAL VOGUE SYSTEM S15 Installation And Servicing page 42

40 Men U oP e RAtio n
Sy Ste M fR o St P Rote Ction
This feature can only be accessed if an outside sensor
has been connected. The pump will run continuously if the
outside temperature is less than 5
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
Show Efficiency Level
System Frost Protection
Reset Service Time
Plot Graphs
Press ENTER and a screen similar to the following will be
displayed.
System Frost Protection
ON press
SAVE press
OFF
Pump may run during night
Press "+" to activate or "-" to de-activate.
Press Ex IT twice to return to normal operation.
Re Set Se RViCe t iMe
If the boiler has not been serviced within the last 12 months
then a message will be displayed indicating this. To reset this
timing proceed as follows.
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
System Frost Protection
Reset Service Time
Plot Graphs
Bus Address
Press ENTER and the following screen will be displayed.
Reset Service Time
279
days
Reset press
Service
due
Press ENTER to reset.
Press Ex IT to return to normal operation.
42 42
in St All Ation inStAllAtion
o
C.
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Plot G RAPHS
To plot graphs of Water Pressure, Switched Live, Flow/Return
Temperature, Flame Status, Outside Temperature or Cylinder
Switched Live press ENTER and the following screen will be
displayed.
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
Reset Service Time
Plot Graphs
Bus Address
Maximum Flow Temperature
Press ENTER and the following screen will be displayed.
Plot Graphs: Select
Data
Water Pressure
CH Switched Live
Flow Temperature
Return Temperature
Press "+" & "-" to highlight the desired input and then ENTER to
select. Press Ex IT 3 times to return to normal operation.
bUS Add Re SS
This feature is only required if the boiler is connected to an
Ideal Cascade Manager (available 2014). Each boiler in the
cascade should be configured to a different bus address. To
change the bus address press ENTER.
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
Plot Graphs
Bus Address
Maximum Flow Temperature
Installer's Details
Press ENTER and a screen similar to following will be displayed.
Bus Address
02
Only changed for
Multiple Boiler Installations
Press "+" or "-" to change the address.
Press ENTER and then Ex IT to return to normal operation.
vogue system boiler -
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Installation and Servicing