IDEAL VOGUE SYSTEM S15 Installation And Servicing page 39

36 CHAn Gin G Settin GS
To switch Cylinder &
CH o ff: move the On/Off
switch into the Off position,
the screen on the right
will be shown (note: Frost
protection still active)
To switch Cylinder &
CH o n: move the On/Off
switch into the On position,
the screen on the right will
be shown
37 Men U oP e RAtio n
Vent Sy Ste M
The Vent System feature aids removal of air from the heat
exchanger. The pump will be switched on for 50s and then off
for 10s. The feature lasts for 5 minutes.
Press ENTER and the following screen will be displayed
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "+" and the following screen will be displayed.
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Press ENTER and the following screen will be displayed.
Vent System
Pump will be pulsed
On 60s, Off 10s
OFF
Diverter Valve
alternates CH/DHW
Press ENTER and the following screen will be displayed.
Vent System
Pump pulsed
On 60s, Off 10s
ON
Diverter Valve
alternates CH/DHW
The feature will end automatically after 5 minutes, to end
manually press Ex IT.
vogue system boiler -
in St All Ation inStAllAtion
OFF
Boiler Switched Off
ON
Boiler Switched Off
Enter
Exit
Enter
Exit
Enter
Exit
Exit
Installation and Servicing
To change the Boiler
t emperature Set Point:
OFF ON
rotate the Boiler
Temperature Control
Knob, the screen on the
right will be shown
To change the Room
t emperature Set Point
(only if Outside Sensor
OFF ON
connected): rotate the
Boiler Temperature Knob,
the screen on the right will
be shown
MAxi MUM f lo W t e MPe RAt URe
To limit the maximum boiler temperature that can be set from
the Boiler Temperature knob press ENTER and the following
screen will be displayed (note that this could prevent adequate
room temperature being achieved in winter).
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Press ENTER and the following screen will be displayed.
70
Set Maximum Flow Temperature
Press "+" and "-" until the desired temperature is displayed and
then ENTER followed by Ex IT to return to normal operation.
70
Set Boiler Temperature
20
ON
Select Room Temperature
Enter
Fault Help Exit
°C
Enter
Exit
°C
°C
39 39