IDEAL VOGUE SYSTEM S15 Installation And Servicing page 40

38 Men U oP e RAtio n
oU t Side Sen So R Slo Pe
This feature is only accessible if an Outside Sensor has
been fitted to the boiler. Boiler performance can be adjusted
relative to the insulation level of the building. To change the
slope press ENTER and the following screen will be displayed
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Fault History
Press ENTER and the following screen will be displayed.
Outside Sensor Slope
80°C
Flow
30°C
-15°C Out' 20°C
1.6
Press "+" and "-" until the desired setting is displayed.
Press ENTER followed by Ex IT to return to normal operation.
fAU lt Hel P
This feature provides a list of potential corrective actions at an
installer level for all faults detectable by the boiler electronics
Press ENTER and the following screen will be displayed
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
Outside Sensor Slope
Fault Help
Fault History
State of Inputs
Press ENTER and the following screen will be displayed.
Overheat Lockout
Fill System to 1.0 Bar
Vent System, Refill System
Check Pump Spins Freely
Check 240V to Pump
Press "+" and "-" to scroll through the information.
Press Ex IT twice to return to normal operation.
40
inStAllAtion in St All Ation
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Enter
Exit
Exit
fAU lt Hi Sto Ry
To view the Fault History of the boiler press ENTER and the
following screen will be displayed
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
Fault Help
Fault History
State of Inputs
State of Outputs
Press ENTER and a screen similar to the following will be displayed.
Fault History
Water Pressure: 17 Minutes
Ago
Ignition Lockout: 3 Days Ago
Overheat Lockout: 2 Months
Ago
No Water Flow: 1 Year Ago
Press "+" and "-" to view the full list.
Press Ex IT twice to return to normal operation.
St Ate of in PUt S
To view the current Water Pressure, Switched Live Status,
Flow Temperature, Return Temperature, Flame Status,
Outside Temperature, Cylinder Switched Live Status and
OpenTherm Status press ENTER and the following screen will
be displayed.
MENU
Vent System
Maximum Flow Temperature
Outside Sensor Slope
Fault Help
Press "-" until the following screen is displayed.
MENU
Fault History
State of Inputs
State of Outputs
Service Mode Minimum Rate
Press ENTER and a screen similar to following will be displayed.
State of Inputs
Water Pressure: 1.3 Bar
CH Switched Live: On
Flow Temperature: 70°C
Return Temperature: 60°C
Press "+" and "-" to view the full list.
Press Ex IT twice to return to normal operation.
vogue system boiler -
Enter
Exit
Enter
Exit
Exit
Enter
Exit
Enter
Exit
Exit
Installation and Servicing