Connecting Wirelessly Using The Configuration Wizard - Fritz! 450E Installation Instructions Manual

Connecting Wirelessly Using the Configuration Wizard

4.
5.
The connection with the wireless access point is re-estab-
lished automatically.
3.2 Connecting Wirelessly Using the Configuration Wizard
If you cannot use WPS, establish the wireless connection us-
ing the configuration wizard.
The configuration wizard is started in the web browser.
Requirements
•
•
•
•
FRITZ!WLAN Repeater 450E
Wait until the LEDs displaying signal strength light up on
the FRITZ!WLAN Repeater.
The connection is established.
Select the best location for expanding the wireless radio
network; for more information, see
Insert the the FRITZ!WLAN Repeater into an electrical
outlet at that location.
The "WLAN Bridge" operating mode must be set in the
FRITZ!WLAN Repeater (preconfigured upon delivery of
the FRITZ!WLAN Repeater).
DCHP must be enabled on the computer; see
an IP Address Automatically
The SSID (radio network name) of the wireless access
point must be set to "visible" (announced).
If the MAC address filter of the wireless access point is
enabled, the MAC address of the FRITZ!WLAN Repeater
must be entered as an exception.
14
6 seconds
page 16.
Obtaining
on page 44.