Cannot Access Devices In The Network - Fritz! 450E Installation Instructions Manual

Cannot Access Devices in the Network

check the user interface (see
For connections to the wireless access point the
FRITZ!WLAN Repeater applies the encryption method and net-
work key of the access point. If the connection was estab-
lished using WPS, the access point has WPA/WPA2 encryp-
tion configured.
Cause
Another wireless radio network in the vicinity of the
FRITZ!WLAN Repeater and the wireless access point is caus-
ing interference.
Help
Test a different radio channel. If possible, set automatic radio
channel selection in the wireless access point. Your
FRITZ!WLAN Repeater then will use the same channel auto-
matically.
16.5 Cannot Access Devices in the Network
No other devices in the network can be accessed.
Cause
A firewall is running on the devices.
Help
Configure the firewall to allow access to the network.
Cause
The devices are not configured to receive their IP addresses
automatically.
Help
Set up the devices as directed in the section
Address Automatically
Cause
FRITZ!WLAN Repeater 450E
page 21).
from page 44.
43
Obtaining an IP